AC voltage for binary inputs

Protecta Help Desk Tudástár EuroProt+ HW platform

If you wish to use AC voltage for the binary inputs, the following has to be considered:

1) Check the rated voltage of the binary input card. The EuroProt+ "Hardware Description" contains this information. The indicated value is valid for AC and DC voltages as well.

2) By using AC voltage, the sinus wave may cause disturbances in the analogue/digital signal conversion. In order to avoid any malfunction of the logical input, a falling edge delay of 16ms shall be set in the EuroCAP configuration tool as shown in the attachment.

» BI_falling_edge_delay.png

Cikk részletei

cikkazonosító:

Kategória:

EuroProt+ HW platform

Értékelés :

Vissza

Kapcsolódó cikkek

Local/Remote switching via binary input
50Hz frequency difference is shown under synchronous conditions with the circuit breaker closed
Analogue input assignment check and modification for function blocks
Under/overvoltage function does not start at the set limit
Do the EP+ devices lose any information without auxiliary power?

Javasolt tudásbázis cikkek:

AC voltage for binary inputs

Cikk részletei

Kapcsolódó cikkek